Press MODE button. For each press, operation mode
changes as follows:
Then select HEAT operation
Press TEMP. button
Every time the button is pressed, temp.setting
increase 1 C,if kept depressed, it will increase
rapidly
Every time the button is pressed, temp.setting
decrease 1 C,if kept depressed, it will decrease
rapidly
Select a desired temperature.
3.Select temp.setting
DRY HEATCOOL
Heat Operation
Air conditioner is running under displayed fan speed.
Operation
Remote Controller
Link with electric power.
The liquid crystal will display the working state of last
time (Except Timer, Power/Soft airflow).
1. Unit start
2. Select operation mode
Press ON/OFF on the remote controller, unit start.
Remote controller:
5. Unit stop
4. Fan speed selection
Press ON/OFF button, the unit stops.
follows:
Remote controller:
When FAN is set to AUTO,the air conditioner
automatically adjusts the fan speed according to room
temperature.
Press FAN button. For each press. fan speed change as
On cooling only unit, heating mode is not available.
In HEAT mode, warm air will blow out after a short period
of the time due to cold-draft prevention function.
LOWHI MEDAUTO
9
To Next Page
Loading...
Need help?
General
