EasyManua.ls Logo

Haier HW50-1010 - Error Signals

Haier HW50-1010
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
Error message Cause Solution
1:
The start indicator wasn't lighted,and the
buzzer sound abnormaly.
Door not shut pr operly. Shut door properly.
2:
The start indicator lighted on 0.2s and
off 0.2s for twice,repeate 4s later .
Drainage error, water has not emptied
within 4 minutes.
Clean the filter (page 15) and check drain
hose for blockages. If pr oblem continues,
contact an appr oved service engineer.
3:
The start indicator lighted on 0.2s and
off 0.2s for 3 times,repeate 4s later .
Temperature sensor is not properly
connected or damaged.
Contact an appr oved service engineer.
4:
The start indicator lighted on 0.2s and
off 0.2s for 4 times,repeate 4s later .
Heating element error, set temperature
is not reached within specifi ed time
(this will be displayed at the end of the
programme).
Contact an appr oved service engineer.
5:
The start indicator lighted on 0.2s and
off 0.2s for 5 times,repeate 4s later .
Correct water level not reached within 8
minutes.
Ensure the tap is fully open and water
pressure is normal. If problem continues,
contact an appr oved service engineer.
6:
The start indicator lighted on 0.2s and
off 0.2s for 6 times,repeate 4s later .
Timer error. Contact an appr oved service engineer.
7:
The start indicator lighted on 0.2s and
off 0.2s for 7 times,repeate 4s later .
Motor overheating. Contact an appr oved service engineer.
8:
The start indicator lighted on 0.2s and
off 0.2s for 8 times,repeate 4s later .
Water overflow. Contact an appr oved service engineer.
Error Signals
The door lock light will flash in different combinations to signal when ther e is an error, see the table below
for the meanings.
Error
Error
Error
Error
Error
Error
Error
Error

Related product manuals