Why is my Haier Washer not working?
If your Haier Washer fails to operate, several factors could be at play. First, ensure that you've started the program correctly. Next, check that the door is securely closed. The machine also needs to be switched on and have a stable power supply. Finally, verify that the child lock feature is deactivated.
Why is my Haier Washer vibrating so much during spinning?
A strong vibration while spinning in your Haier Washer can occur if the transportation bolts haven't been removed. It's also possible that the appliance isn't on solid, level ground, or the machine load is not correct. Remove all transportation bolts, ensure solid ground and a leveled position, and check load weight and balance.
Why is my Haier HW70-B1239N Washer draining constantly?
If your Haier Washer is constantly draining, it might be because the drain hose is positioned too low (below 80 cm). Also, check that the drain hose end is not submerged in water. Make sure that drain hose is properly installed and is not in water.
What to do if my Haier HW70-B1239N Washer is not filling with water?
If your Haier Washer isn't filling with water, start by checking if the water tap is open. Inspect the inlet hose for any kinks that might be blocking the water flow. Also, make sure that the water pressure meets the minimum requirement of 0.03 MPa and that the door is properly closed. Finally, ensure that there are no issues with the general water supply.
What to do if my Haier HW70-B1239N Washer stops mid-cycle?
If your Haier Washer cycle stops prematurely, it could be due to a water or electric failure. Check both your power and water supply to ensure they are functioning correctly.
Why is my Haier HW70-B1239N Washer experiencing drainage failure?
If your Haier Washer is experiencing drainage failure, it could be due to a blocked drain hose, or the drain hose end being higher than 100 cm. Make sure that drain hose is properly installed.
What to do if the Haier Washer displays error E4?
If your Haier Washer shows error code E4, it means the water level hasn't been reached or the drain hose is self-syphoning. Ensure the tap is fully opened, and the water pressure is normal. Also, check the drain hose installation.
What to do if Haier HW70-B1239N Washer displays error E2?
If your Haier Washer displays error E2, it indicates a lock error. Make sure that the door is properly shut.
What to do if my Haier HW70-B1239N displays ';!
If your Haier Washer displays the error ';!
What does error code E4 mean on my Haier Washer?
If your Haier Washer displays the error code 'E4', this indicates that the water level isn't being reached. Ensure the tap is fully opened and the water pressure is normal. Another possible cause is that the drain hose is self-siphoning, so check the drain hose installation.
To Next Page
General
