Why are there washing powder residues on my laundry after using my Haier HW70-BP14929?
If you find washing powder residues on your laundry after washing with your Haier Washer, try performing an extra rinse. You can also try to brush the points from the dry laundry or choose another detergent.
Why is there no water in my Haier Washer?
If your Haier Washer isn't filling with water, consider these potential causes: * Check that the water tap is open. * Inspect the inlet hose for kinks. * Verify that the water pressure is at least 0.03 MPa. * Ensure the door is properly closed. * Confirm that there is no water supply failure.
Why is my Haier HW70-BP14929 constantly draining?
If your Haier Washer is draining constantly, ensure that the drain hose is properly installed and that its height is not below 80 cm. Also, make sure the drain hose end is not in water.
How to troubleshoot spinning failure on Haier Washer?
If the spinning function fails on your Haier Washer, check the machine load and laundry distribution. Then, run a spinning programme again.
What to do if my Haier HW70-BP14929 Washer operation stops before completing wash cycle?
If your Haier Washer stops before completing the wash cycle, check both the power and water supply to ensure they are functioning correctly.
Why does my laundry have grey patches after washing in my Haier HW70-BP14929?
If your laundry has grey patches after washing in your Haier Washer, it's likely caused by fats such as oils, creams, or ointments. Pretreat the laundry with a special cleaner before washing.
What does error FC0 / FC1 or FC2 mean on my Haier Washer?
If your Haier Washer displays error code FC0, FC1, or FC2, this indicates an abnormal communication error. Contact the After sales service.
What does error E8 mean on my Haier Washer?
If your Haier Washer displays error code E8, this indicates a water protective level error. Contact the After sales service.
How to improve the washing result of my Haier HW70-BP14929 Washer?
If you're not satisfied with the washing result from your Haier Washer, try these adjustments: * Select a different programme that better suits the degree of pollution. * Ensure you're using enough detergent, following the manufacturer's specifications. * Reduce the load if you've exceeded the maximum capacity. * Loosen the laundry if it's unevenly distributed in the drum.
What does 'CLR FLTR' mean on my Haier HW70-BP14929?
If your Haier Washer displays 'CLR FLTR', it indicates a drainage error where water isn't fully drained within 6 minutes. Check the drain hose installation.
Safety precautions before the initial operation of the washing machine, including transport damage checks.
Guidelines and warnings for safe operation during everyday use, covering operation and interaction.
Safety measures to follow when cleaning or performing routine maintenance on the appliance.
Safety instructions related to the proper installation environment and electrical connections.
Information on the designated purpose and limitations of the appliance, and unauthorized modifications.
Visual identification of the front and rear parts of the washing machine with numbered components.
List and identification of accessories provided with the washing machine for installation and use.
Explanation of turning the machine ON/OFF, the program selector, and display information.
Details on the compartments and proper usage of the detergent dispenser for powder or liquid.
Detailed usage of Delay, Time, Temp, Speed, Extra Rinse, Start/Pause, and Child Lock functions.
Table detailing programs, load capacity, temperature, spin speed, and fabric types for effective washing.
Data on energy efficiency, water usage, and performance for various programs based on load size.
Instructions for connecting the appliance to power and water supplies safely and correctly.
Tips for sorting, preparing, and loading laundry into the machine for optimal washing results.
Guidance on choosing correct detergent types and amounts for different fabrics and programs.
Step-by-step instructions for adding cleaning agents into the dispenser compartments.
Procedures for switching on, selecting programs, and adding options before starting a wash.
How to pause, interrupt, or cancel an ongoing wash program and restart it.
Actions after washing, including door lock management, energy saving, and buzzer settings.
Tips for using the appliance efficiently to save energy, water, and detergent.
Instructions for removing and cleaning the detergent dispenser to prevent residue buildup.
How to clean the outer casing and rubber components of the washing machine using a soft cloth.
Steps for cleaning the water inlet valve and its filter to prevent blockages from solid substances.
Recommendations for cleaning the drum and removing rust stains or damage from foreign objects.
Procedures for preparing the appliance for periods of disuse to prevent damage and odors.
Detailed guide on how to clean the appliance's pump filter, including safety warnings.
Explanations of codes that display informational messages during washing cycles.
Solutions for problems indicated by specific error codes on the appliance's display.
Solutions for operational problems, including those without display codes and power failures.
Steps for unpacking and preparing the appliance for installation, including disposal of packaging.
Optional steps for fitting pads to minimize operational noise during use.
Instructions on how to safely remove transport bolts to prevent inner damage.
Guidance on moving the appliance and adjusting its feet for stability and reduced vibration.
Methods for connecting the drain hose to a sink or waste water outlet, ensuring proper drainage.
Steps for connecting the appliance to water supply and electrical power, ensuring safety.
Key technical data including voltage, current, power, water pressure, and net weight.
Measurements and required clearances for the washing machine installation.
Information regarding EC directives and CE marking compliance for the product.
How to contact Haier customer service for assistance, including checking troubleshooting sections.
Contact information and postal addresses for Haier service centers across Europe.
Safety precautions before the initial operation of the washing machine, including transport damage checks.
Guidelines and warnings for safe operation during everyday use, covering operation and interaction.
Safety measures to follow when cleaning or performing routine maintenance on the appliance.
Safety instructions related to the proper installation environment and electrical connections.
Information on the designated purpose and limitations of the appliance, and unauthorized modifications.
Visual identification of the front and rear parts of the washing machine with numbered components.
List and identification of accessories provided with the washing machine for installation and use.
Explanation of turning the machine ON/OFF, the program selector, and display information.
Details on the compartments and proper usage of the detergent dispenser for powder or liquid.
Detailed usage of Delay, Time, Temp, Speed, Extra Rinse, Start/Pause, and Child Lock functions.
Table detailing programs, load capacity, temperature, spin speed, and fabric types for effective washing.
Data on energy efficiency, water usage, and performance for various programs based on load size.
Instructions for connecting the appliance to power and water supplies safely and correctly.
Tips for sorting, preparing, and loading laundry into the machine for optimal washing results.
Guidance on choosing correct detergent types and amounts for different fabrics and programs.
Step-by-step instructions for adding cleaning agents into the dispenser compartments.
Procedures for switching on, selecting programs, and adding options before starting a wash.
How to pause, interrupt, or cancel an ongoing wash program and restart it.
Actions after washing, including door lock management, energy saving, and buzzer settings.
Tips for using the appliance efficiently to save energy, water, and detergent.
Instructions for removing and cleaning the detergent dispenser to prevent residue buildup.
How to clean the outer casing and rubber components of the washing machine using a soft cloth.
Steps for cleaning the water inlet valve and its filter to prevent blockages from solid substances.
Recommendations for cleaning the drum and removing rust stains or damage from foreign objects.
Procedures for preparing the appliance for periods of disuse to prevent damage and odors.
Detailed guide on how to clean the appliance's pump filter, including safety warnings.
Explanations of codes that display informational messages during washing cycles.
Solutions for problems indicated by specific error codes on the appliance's display.
Solutions for operational problems, including those without display codes and power failures.
Steps for unpacking and preparing the appliance for installation, including disposal of packaging.
Optional steps for fitting pads to minimize operational noise during use.
Instructions on how to safely remove transport bolts to prevent inner damage.
Guidance on moving the appliance and adjusting its feet for stability and reduced vibration.
Methods for connecting the drain hose to a sink or waste water outlet, ensuring proper drainage.
Steps for connecting the appliance to water supply and electrical power, ensuring safety.
Key technical data including voltage, current, power, water pressure, and net weight.
Measurements and required clearances for the washing machine installation.
Information regarding EC directives and CE marking compliance for the product.
How to contact Haier customer service for assistance, including checking troubleshooting sections.
Contact information and postal addresses for Haier service centers across Europe.
To Next Page
General
