EN
9-Troubleshooting
23
E-,0A+8 Cause 5,A1'(,6
'2
• Temperature sensor error. • Contact the After sales service.
'.
• Heating error.
• Contact the After sales service.
'8
• Motor error. • Contact the After sales service.
'9
• Water level sensor error.
• Contact the After sales service.
':+
or ':3%or%
':-
• Abnormal communication error.
• Contact the After sales service.
;!<
• @/G0.0/#()$.,0)$$(++,+? • Check and balance laundry load in the drum.
E-,0A+8 Cause 5,A1'(,6
Washing machine fails
to operate.
• Programme is not yet started. • Check programme and start it.
• Door is not properly closed. • Close the door properly.
• Machine has not been switched on. • Switch the machine on.
• Power failure. • Check power supply.
• Child lock is activated. • Deactivate child lock.
Washing machine
"..$/,&$G($%..()$ "&!$
water.
• No water. • Check water tap.
• Inlet hose is kinked. • Check inlet hose.
• 9/.(&$!,'($%.&(+$"'$G.,#U()? • @/G.,#U$"/.(&$!,'($%.&(+?$
• Water pressure is less than 0.03 MPa.
• Check water pressure.
• Door is not properly closed. • Close the door properly.
• Water supply failure. • Ensure the water supply.
Machine is draining
!".($G("/*$%..()?
• Height of drain hose is below 80 cm.
• Make sure that drain hose is
properly installed.
• Drain hose end could reach into
water.
• Make sure the drain hose is not
in water.
Drainage failure. • Drain hose is blocked. • @/G.,#U$)+0"/$!,'(?
• B145$%.&(+$"'$G.,#U()? • <.(0/$5145$%.&(+?
• Drain hose end is higher than 100 cm
0G,N($A,,+$.(N(.?
• Make sure that drain hose is
properly installed.
Strong vibration while
spinning.
• Not all transportation bolts have
been removed.
• Remove all transportation bolts
.
• Appliance has no solid position.
• Ensure solid ground and a levelled
position.
• Machine load is not correct. • Check load weight and balance.
Operation stops
before completing
wash cycle.
• Water or electric failure. • Check power and water supply.
Operation stops for
a period of time.
• Appliance displays error code. • Consider display codes.
• Problem due to load pattern. • Reduce or adjust load.
• Programme performs soaking cycle.
• Cancel programme and restart.
F!#$H-,10A+</,,'(6:$>('/,1'$.(<?A*7$&,.+
To Next Page
Loading...
Need help?
General
