7) Water Temperature (Wash / Rinse)
• To select inlet water temperature for wash and rinse. Selection may vary per the cycle
chosen. All selections are not available in all cycles. Follow fabric care labels for best
results.
8) Beeper (Signal)
• Signal volume can be adjusted soft–loud or off. As adjusted, signal will sound during
selection of cycles or options and when wash cycle is completed. At the end of washing
cycle the unit will sound 3 long beeps. When choosing an option, if signal beeps twice
it means that the option is not available. A signal will sound if the washer goes in error
status.
9) Extended Spin
• To increase spin time activate this option. This helps to remove extra water and saves
drying time. Once the wash load is in the spin cycle this pad can not be activated.
10) Stain Treat
• This function increases the wash time in different cycles. Use this for very heavily soiled
clothes.
11) Rinse & / Spin
• This option is used for clothes that do not need to be washed. Clothes sitting in a drawer
or hanging in the closet for a long time may not only need to be rinsed and spun to make
them feel fresh again.
Touch pad to select this option. The washer will now switch off the wash mode and will be
in the rinse and spin cycle. Touching the pad for a second time will set the washer to spin
only.
The rinse and spin speeds could be changed by touching their respective pad (5 & 6).
The "Wash" "Rinse" & "Spin" icons by the Time Display Zone (16) will be lit to indicate the
selected function.
12) Delay
• With the machine in standby, you can chose a delay start time from 1-30 hours. To do so,
touch the delay pad. Each touch of this pad advances the delay in one hour increments. To
activate the delay function touch the Start / Pause (3) pad. Doing so will cause the delay
(12) pad to ash. When set at 24:00, push the delay pad again and the delay time is
cancelled. After setting if wash program is change delay time is cancelled.
13) Prewash
• Use this option for heavily soiled clothes. By activating this it will add wash time before
the main wash to the wash cycle. The RINSE &/ SPIN option can not be selected if this
function is activated.
Note: Remember to add detergent to the Prewash compartment of the dispenser drawer.
14) Custom Program
• To customize your favorite wash programs simply choose your cycle, wash settings and
options and touch the "Custom Program" pad (Approximately 3 Seconds) until a beep
confirms the settings. Time display will show “rb”. A maximum of 10 programs can be
stored, one for each cycle. To use your saved setting, go to the desired cycle and touch the
"Custom Program" pad. The washer will automatically go to the saved setting.
15) Child Lock
• When the machine is running, in pause or in delay cycle, press the RINSE &/ SPIN pad
for more than 3 seconds, child lock will activate. Touch again to cancel the child lock. You
can unlock the child lock function only by touching this pad. Power off, program finish, or
unplugging the power will not unlock the child lock! If the child lock function is activated,
the child lock LED is on; if not, the child lock LED is off.
English
13
To Next Page
Loading...
Need help?
General
