EasyManua.ls Logo

HAKO Scrubmaster B8 - 6.5 GROUND PRESSURE REGULATION SELECTOR FOR THE BRUSH (FIG. 1); 7.1 MOVING THE MACHINE (Fig. 1); 8.1 FILLING IN THE CLEAN WATER TANK; 8.1.a - Filling in the tank on the machine

HAKO Scrubmaster B8
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGLISH -
9
6.5 GROUND PRESSURE
REGULATION SELECTOR
FOR THE BRUSH (FIG. 1)
- Use the selector (15) to adjust the ground
pressure of the brush; to switch from one
pressure to another, turn the selector
(15):
to increase the pressure, turn the se-
lector (15) counter clockwise;
to decrease the pressure, turn the se-
lector (15) clockwise;
NOTE:
You cannot switch directly from the minimum
pressure “A” to the maximum pressure “C”
or vice versa
You should always go from the average
pressure “B”.
Position “A” = Minimum pressure
Position “B” = Average pressure
Position “C” = High pressure
NOTE:
If the ground pressure is high, the battery
charge duration will shorten.
7.1 MOVING
THE MACHINE (Fig. 1)
- Lift the brush (9) using the pedal (10).
- Move the machine by pushing the handle
bar (1).
8.1 FILLING IN THE CLEAN
WATER TANK
WARNING:
Ensure that the machine is turned off and,
in case of a machine with a charger, en-
sure that the plug is disconnected from
the AC power outlet.
WARNING:
Only add clean mains water to the tank at
a temperature no greater than 50°C.
WARNING:
If the detergent comes in contact with the
eyes and/or skin or if swallowed, refer to
the use and safety information booklet
provided by the manufacturer of the de-
tergent.
Seek medical aid, if necessary.
The filling in of the tank (12 Fig. 1) can be
made with the tank on the machine or with
the tank removed.
- Release the lever (16 Fig. 13) for closing
the tank lid and lift the lid (11 Fig. 13).
8.1.a - Filling in the tank on the ma-
chine (Fig. 14)
- Lift the lid (41) of the clean water tank
(12) and place it turned inside the recov-
ery water tank (13).
- Fill in the tank (12) with clean water up to
the maximum level “MAX”.
- Pour the liquid detergent inside the lid
(41) in order to ease the dosage; the
inside of the lid features a graded scale
indicating the quantity of detergent in %
depending on the quantity of water in the
tank.
- Turn the lid (41) by placing it above the
tank (12) pouring the liquid detergent in-
side the tank
Manu_HAKO_Scrubmaster_B8_1ed_01-2020_49027807.indd 9Manu_HAKO_Scrubmaster_B8_1ed_01-2020_49027807.indd 9 23/01/2020 13:59:4823/01/2020 13:59:48

Table of Contents

Related product manuals