HAKO Scrubmaster B8 - TROUBLESHOOTING

ENGLISH - 14
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
If the levers on the handle
bar are pressed, the ma-
chine does not start.
Low battery (battery version
only).
Check that the battery is
charged.
Plug disconnected (charger
version only).
Connect the plug.
The brush does not rotate. Levers on the handle bar not
pressed.
Press the levers.
Brush rotation enabling but-
ton not pressed.
Press the button.
Brush motor damaged. Replace the engine.
Aspirator does not work. Vacuum cleaner turned off. Start the vacuum cleaner by
pressing the corresponding
button.
Intake motor damaged. Replace the turbine.
The machine does not dry
well, leaving traces of water
on the floor.
Aspirator off. Start the vacuum cleaner by
pressing the corresponding
button.
Obstructed vacuum tubes. Check and if necessary
clean the vacuum tubes that
connect the wipers to the re-
covery tank.
Dirty wiper rubber blades. Clean the rubber blades of
the wiper.
Squeegee rubber blades
worn.
Replace or turn over the
squeegee rubber blades.
The machine turns off. Low battery. Charge battery.
Recovery tank full. Empty the tank.
No water comes out. Tank empty. Fill the tank.
Filter blocked. Clean the filter.
Pump not functioning. Call the technical support
service.
Insufficient floor cleaning. Inadequate brush or deter-
gent.
Use brush or detergents ad-
equate to the type of floor or
dirt to be cleaned.
Brush worn. Replace the brush.
Manu_HAKO_Scrubmaster_B8_1ed_01-2020_49027807.indd 14Manu_HAKO_Scrubmaster_B8_1ed_01-2020_49027807.indd 14 23/01/2020 13:59:5223/01/2020 13:59:52