Halo BOLT 57720 - User Manual

Other manuals for Halo BOLT 57720

Quick Start Guide2 pages

Questions and Answers

J
Jamie WadeJul 27, 2025
What to do if Halo BOLT Remote Starter Jump Start button flashes red and blue?
- L
  Laura NicholsonJul 27, 2025
  If the Jump Start and On/Off button on your Halo BOLT flashes red and blue, it could be due to attempting to jump start the vehicle while other electrical components, such as headlights, heater, or radio, are on. Turn off your headlights and any other components that may be draining your car battery and try the jump start process again. The vehicle battery may also be faulty.
K
Katrina WangAug 2, 2025
Why does my Halo BOLT Remote Starter flash red?
- C
  Christopher McdowellAug 2, 2025
  The Halo BOLT may flash red because the jumper cables have not been properly connected to the vehicle battery. To fix this, check the jumper cables and ensure that the red clamp is connected to the positive terminal (+) and the black clamp is connected to the negative terminal (-).
K
kimberly78Aug 8, 2025
How to fix Halo BOLT Remote Starter Jump Start button flashing green continuously?
- A
  Angel GrayAug 8, 2025
  If the Jump Start button on your Halo Bolt flashes green continuously, it means the Halo Bolt is waiting to be connected to a battery. Check the jumper cables and ensure they are properly connected to the battery.
M
Michele MarshallAug 13, 2025
Why does my Halo BOLT Remote Starter shut off unexpectedly?
- A
  Amy GriffinAug 13, 2025
  Your Halo BOLT may shut off unexpectedly because it isn't sufficiently charged to jump start the vehicle. To resolve this, recharge the Halo BOLT. Alternatively, the Halo BOLT may detect that it is connected to a vehicle battery that does not require a jump start, which could indicate a faulty vehicle battery or component.
A
Anne CervantesAug 19, 2025
What does it mean when Halo BOLT Remote Starter battery indicators flash green?
- M
  Mr. Gerald BoydAug 20, 2025
  When the battery indicators on your Halo BOLT flash green, it means the device has detected a high temperature condition. Disconnect the Halo BOLT and allow it to cool for several minutes. Then try the jumpstart process again.