15
Troubleshooting
Odor or burning smell.
•
Flour or other ingredients have spilled into Baking Chamber. Stop
Bread Maker and allow to cool completely. Wipe excess flour, etc.,
from Baking Chamber with a paper towel.
Tip: Measure ingredients over counter, adding them to Bread Pan
prior to insertion into machine.
Ingredients not blending; can hear motor turning.
•
Bread Pan or Kneading Paddle may not be installed properly. Make
sure Kneading Paddle is securely installed on Shaft.
•
Too many ingredients. Measure ingredients accurately.
Window is cloudy or covered with condensation.
•
May occur during mixing or rising cycles. Condensation usually
disappears during baking cycle. Clean Window well in between uses.
Kneading Paddle comes out with bread.
•
Thicker crust with dark crust setting. Choose a lighter crust (Cycles 1,
2, 4, or 9 only).
•
It is not uncommon for Kneading Paddle to come out with bread loaf.
Once loaf cools, remove Paddle with Paddle Hook.
Bread rises too high or pushes Lid up.
•
Ingredients not measured properly (too much yeast, flour). Measure
all ingredients accurately and make sure sugar and salt have been
added.
•
Kneading Paddle not in Bread Pan. Check installation of Kneading
Paddle.
•
Forgot to add salt.
•
Try decreasing yeast by 1/4 teaspoon (1 g).
Dough is not blending thoroughly; flour and other ingredients are built
up on sides of pan; bread loaf is coated with flour.
•
Bread Pan or Kneading Paddle may not be installed properly. Make
sure Bread Pan is securely set in unit and Kneading Paddle is firmly
on Shaft.
•
Too many dry ingredients. Make sure ingredients are measured
accurately and added in proper order. Use a rubber spatula to
scrape sides of pan while Bread Maker is mixing to ensure all
ingredients are blended.
•
Gluten-free dough is typically very wet. It may need additional help
by scraping sides with a rubber spatula.
•
Excess flour can be removed from loaf once baked and cooled. Add
water, one tablespoon at a time, until dough has formed into a ball.
Bread does not rise; loaf is short.
•
Inaccurate measurement of ingredients or inactive yeast. Measure all
ingredients accurately. Check expiration date of yeast and flour.
•
Lifting Lid during cycles.
LLL on Control Panel.
•
Bread Maker is too cold. Allow Bread Maker to come to room
temperature.
EE0 or EE1 on Control Panel.
•
There is a problem with your Bread Maker. Email or write Customer
Service.
HHH on Control Panel.
•
Bread Maker is too hot. Let cool down before using.
To Next Page
Loading...
