Document #101-0204 23 10/21/2011
Additional Wire Terminations For Camera In HTK.
The installation of the machine should proceed as outlined in the above section. However, if a Camera
System is being used, the following must be performed, as well.
• A Video cable (shielded coaxial cable) should be pulled to each HTK
on the site. The cable should be run from were the connection to the
camera system is located back to the HTK. When terminating the
video cable consult an electrician or network person for proper attach-
ment.
NOTE: When running video cable, the run should be made
with out any splicing or mid point connections. If there are this
can lead to communication issues. Hamilton supplies on the HTK
side a standard BNC connector for video.
• The Video cable can be run in with the low voltage wires coming from
the car wash.
Additional Wire Terminations for Help Button in HTK.
The installation of the machine should proceed as outlined in the above section. However, if a Help
Button is being used, the following must be performed as well.
• Two 18 guage wires should be pulled to each HTK on site. The wires
should be run from were the connection to the intercom system is lo-
cated back to the HTK. When terminatng the wires consult an electri-
cian or network person for proper attachment.
Note: The HELP Button is a set of contacts that close when the
button is pressed. The intention of the Help button is to be con-
nected to a third party intercom system.
• The wires pulled to the Help buttom can be run in with the low voltage
wires coming from the carwash.
To Next Page
Loading...
Need help?
General
