50
Windows 95/98/Me/NT/2000/XP/2003 manual Installation Procedure
Please perform the steps as follows to ensure a smooth installation:
1. Run Setup from the print server’s Setup CD.
2. The Network Print Monitor for Windows 95/98/Me Setup will then appear. Click
Next.
3. A message reading, “Setup is complete. You may add the Network Print Port by using
the PSAdmin” will appear. Click OK.
4. Click Start, point to Settings, and select Printers.
5. Double-click the Add Printer icon.
6. Select Local Printer and click Next.
7. Select the appropriate printer manufacturer and printer type and click Next.
8. Select LPT1 and click Next.
9. Type in the Printer Name and click Next.
10. A message reading, “After your printer is installed, Windows can print a test page so you
can confirm that the printer is set up properly.” Select No and click Finish.
11. Double-click the newly created Printer Name icon.
12. Select Printer and Properties.
13. Click Details tab and select Add Port.
14. In the Add Port dialog box, select Other, as shown in the following picture.
15. Select the Network Print Port and click OK.
To Next Page
Loading...
Need help?
General
