Hammer Bow+ - Battery Charging and Keypad Lock; Charging via Cradle Charger; Keypad Locking and Unlocking

To Next Page

To Previous Page

*Attention: Improper connection of the charger can cause serious

damage to the phone.

Damages caused by an improper use of the phone

are not covered by the warranty.

While charging, a static icon of battery state located in upper right corner

of the screen will become animated. When charging is complete unplug the

charger from the power outlet. Unplug the cable from the socket on the

phone.

Through the cradle charger

Plug in the microUSB cable to microUSB connector in the cradle charger

then connect USB connector to the adapter and that one to low voltage

grid. The green LED on the base should light up. Position the base in a

location where it will be stable and the connected charger cable will not be

exposed to accidental pulling or damage. After folding the flap, the phone

can be inserted into the charging base so that the connectors in the phone

(19) come into contact with the connector in the base of cradle charger.

A correct connection is signalled by a short flashing of the red LED in the

charging base. If everything is in order, the green LED turns off and the red

LED turns on. The proper battery charging process will be signalled by

flashing of the diodes - a few seconds of red light and a short flash of green.

In addition, the external screen of your phone will display an animated LED

icon. When the battery in your phone is fully charged, the icon on the screen

will not be animated, but a fixed image will appear and the LED on the

cradle charger will permanently light up a green. You can then remove your

phone from the charging base.

Battery discharge indicator

When the battery gets discharged, a message of the need to charge it will

be displayed. Battery icon will be ”empty”. If the charge level is too low, the

phone will turn off automatically. To use the phone one has to charge the

battery.

3. Using the basic functions

Keypad lock

The keypad locks itself automatically after the time set by the user. It can

also be locked manually. To do this, press the <Menu> button and then

press the <*> button. To unlock the keyboard (when the display is blanked)

one should press any key to activate the screen, then press <unlock>

button (located at the bottom left corner of the display), followed by the

<*> button on the keyboard. The keypad is unlocked.