Hammerhead ONGA - Cleaner Leaves Patches; Cleaner Sticks on Walls;Floors; Cleaner Not Sitting Flat

14
Problem: Cleaner leaves patches.
Solution: • Ensure the swivel on top of the Hammer Head is rotating freely and
is screwed on securely.
• Adjust Eyeball Diverters downwards.
• Check the footpad under the Hammer Head for wear.
• Verify proper hose length and correct position of the Hose Weights.
• Check that the hose sections are straight; if not straighten up the
coiled hose and lay it in the warm sun for day or two.
• Time switch is not running long enough. Reset time switch.
Problem: Cleaner only cleans the walls.
Solution: • Ensure there is a valve installed in the skimmer/weir.
• Using your Flow Gauge, verify proper water fl ow to your Cleaner.
• Inspect the Regulator Valve and fl ush away any debris buildup.
• Check the footpad under the pool cleaner for wear.
Problem: Cleaner sticks on walls and fl oors.
Solution: • Ensure there is a valve installed in the skimmer/weir.
• Using your Flow Gauge, verify proper water fl ow to your Cleaner.
• Inspect the Regulator Valve and fl ush away any debris buildup.
• Check the footpad under the Hammer Head for wear.
Problem: Cleaner not sitting fl at on bottom. Solution:
• Ensure there is a valve installed in the skimmer/weir.
• Using your Flow Gauge, verify proper water fl ow to your Cleaner.
• Inspect the Regulator Valve and fl ush away any debris buildup.
• Ensure the swivel on top of the Hammer Head is rotating freely and
is screwed on securely.
• Adjust Eyeball Diverters downwards.
• Verify proper hose length and correct position of the Hose Weights.
Trouble Shooting