8
Installation
Ensure the pump and fi ltration system is switched
off before commencing.
Insert the weir adaptors into vacuum lid.
Connect the already measured out hose sections
to the Hammer Head.
1. Insert Flow Gauge into leader hose.
2. Place hose lengths into pool (fi lled with water) and
connect to regulator valve fi tted to weir.
3. Switch on pump and regulate fl ow of water
IMPORTANT: The Flow Gauge is used for test purposes
only and must be removed during normal operation of the
Hammer Head
Switch the pump on and start adjusting the Knob
of the Regulator Valve “Faster” or “Slower” until the
disc indicator in the Flow Gauge settles between
“maximum” and “minimum” fl ow.
Turn the pump off.
Remove the Flow Gauge and connect the pool
cleaner to leader hose.
NOTE: optimizing the water fl ow does not mean
maximizing the fl ow through the Cleaner. In fact, to
insure a random pattern of travel that will enable the
Cleaner to reach all areas of your pool, it is better to
use less suction, not more.
Switch on your pump.
Your fully assembled Hammer Head will start
pulsating immediately.
Skimmer
Regulator
Valve
To Pump
Adjustment Knob
To Next Page
Loading...