Canopy
ring
Hanger Split pin
I I
c-.-
--r-)
\:
)
,
,
Canopy
bottom
cover
Figure 10
Figure 11
Canopy
ring
CLOSE- TO-CEILING INSTALLATION
I. Remove the canopy ring from the canopy
by turning the ring to the right until it
unlocks. (Figure 7)
2. Remove the mounting bracket from the
canopy by loosening the four screws on the
top of the canopy. Remove the two non-
slotted screws and loosen the slotted
screws. This will enable you to remove the
mounting bracket.
3. Remove the decorative canopy bottom
cover from the canopy by depressing the
three studs (Figure 10).
4. Mount the ceiling canopy and the upper
motor housing to the hanger by tightening
the three screws and spring washers
(Figure ll).
,- __ ,.- __ WARNING ---.
FAILURE TO COMPLETELY TIGHTEN THE
THREE SCREWS AND SPRING WASHERS IN
STEP 4 COULD RESULT IN FAN LOOSENING
AND POSSIBLY FALLING.
Installing fan to
the electrical box
1. Pass the l20-volt supply wires through the
center hole in the mounting bracket as
shown in Figure 12.
2. Attach the mounting bracket on the
electrical box by sliding the mounting
bracket over the screws provided with the
outlet box. When using close-to-ceiling
mounting, it is important that the mounting
bracket be level. If necessary, use leveling
washers (not included) between the
mounting bracket and the electrical box.
Note that the flat side of the mounting
bracket is to be toward the electrical box
(Figure 12).
UL listed
electrical
box
Mounting
screws
(supplied with
electrical bOX)
Hook
120V Wires
Figure 12
r-------WARNING ------,
WHEN MOUNTING ON A SLOPED CEILING, THE
STANDARD BALUDOWNROD MOUNTING
METHOD MUST BE USED. MAKE SURE THE
MOUNTING BRACKET SLOTS ARE ON THE
LOWER SIDE BY SLIDING THE MOUNTING
BRACKET FROM THE TOP DOWN.
3. Securely tighten the two mounting screws.
4. Carefully lift the fan assembly up to the
mounting bracket. If using close-to-ceiling
mounting, hang the fan on the hook
provided by utilizing one of the holes at
the outer rim of the ceiling canopy. If
5.
To Next Page
Loading...
