12
Assembly - Attaching the Lights (continued)
Installing the bulbs and glass shade
2
□ Remove the compressing ring (WW) from the threaded
socket of the light kit by turning the compressing ring
counter-clockwise until it unlocks.
□ Insert the glass shade (I) into the light kit cowling and turn
the compressing ring (WW) clockwise to tighten and secure
the glass shade. Repeat for the remaining shades.
□ With power off, screw the LED bulbs (J) (9W, provided) into
the sockets.
□ Attach the pull chain extensions (FF) provided to the light
pull chain and fan pull chain.
CAUTION: Make sure the power is off before attaching or
removing the glass shade.
WARNING: Allow the glass shade to cool completely before
removing.
Turn on the power and check the operation of the fan. The fan pull
chain controls the fan speed as follows:
1 pull - High, 2 pulls - Medium, 3 pulls - Low, 4 pulls - off
The appropriate speed settings for warm or cool weather depends on
factors such as the room size, ceiling height, and number of fans.
The slide switch (XX) controls the direction of the blades: forward
(switch left) or reverse (switch right).
A. Warm weather - (Forward) A downward airow creates a cooling
effect. This allows you to set your air conditioner on a higher setting
without affecting your comfort.
B. Cool weather - (Reverse) An upward airow moves warm air off of the
ceiling. This allows you to set your heating unit on a lower setting
without affecting your comfort.
NOTE: Wait for the fan to stop before reversing the direction of the
blade rotation.
Operation
OPERATING YOUR FAN
A. Warm Weather
B. Cool Weather
FF
E
I
WW
J
XX
XX
To Next Page
Loading...
