Problem
Solution
The fan wobbles.
16
□ Check that all blade and blade arm screws are secure.
□ Most fan wobble problems are caused when blade levels are unequal. Check this level by selecting a
point on the ceiling above the tip of one of the blades. Measure from a point on the center of each blade
to the point on the ceiling. Rotate the fan until the next blade is positioned for measurement. Repeat for
each blade. Measurements deviation should be within 1/8 inch. Run the fan for ten minutes.
□ Use the enclosed blade balancing kit if the blade wobble is still noticeable.
Troubleshooting (continued)
To Next Page
Loading...
Need help?
General
