Hamron HPW-140 - Electrical Connection Safety; Integrated Safety Features

EN
47
Mains connection
• Electrical connections must only be carried out by an authorised electrician.
Electrical connections must comply with IEC60364-1.
• The high-pressure washer must be connected to the mains supply with a
residual current device with a maximum tripping current of 30 mA.
• A temporary voltage drop may occur when starting the high-pressure washer,
which could aect other equipment. Such interference does not normally occur
if the impedance in the mains supply Zmax is less than 0.335ohm. Contact
your electricity supplier for more information.
• An incorrectly connected earthed plug can result in electric shock.
– Consult an electrician or qualied technician if you have any questions
about electrical connections or earthing.
– Never modify the plug in any way.
– If the plug does not t the mains outlet, contact an authorised
electrician to install an earthed mains outlet.
Safety devices
• The high-pressure washer is equipped with an overpressure valve.
• The spray gun has a trigger lock.
• The motor is equipped with overheating protection. The high-pressure washer
starts again after a few minutes, when it has cooled.