EN
55
– to the right for a higher concentration.
– to the left for a lower concentration.
2. Dissolve dirt by applying detergent with the jet set to a wide spray pattern against the dry surface.
3. Work from below and upwards on vertical surfaces.
4. Allow the detergent to act for 1 to 2 minutes, but do not allow it to dry.
5. Rinse o the detergent from the surface from below and upwards.
STORAGE
1. Switch o the high-pressure washer.
2. Close the water tap.
3. Empty the chemicals container.
4. Relieve the pressure in the high-pressure washer by keeping the trigger pressed until no more
water comes out through the nozzle.
5. Lock the trigger.
6. Unplug the power cord.
7. Treat the high-pressure washer with non-corrosive, non-toxic antifreeze before putting into
winter storage. NOTE: Rinse the high-pressure washer with clean water before using it again.
Antifreeze can damage washed surfaces.
10
To Next Page
Loading...
