HAMWORTHY HEATING LTD
2
FLEET H series
500001212/F
2.0 SUPPLY AND DELIVERY
The boiler is despatched to site as a pre-assembled and tested unit. Each boiler is delivered by a tail lift vehicle
and lowered to ground level. It is the installers responsibility to convey the boiler to the plantroom.
NOTE: The Fleet H series boilers are packaged in a wooden crate to allow stacking. Once removed from the
packaging, all boilers can be manoeuvred on a standard pallet truck. However, when handling and manoeuvring
the boiler care must be taken to avoid damage to the casing. The flue system is packaged separately.
The boiler must be kept upright during handling.
The flue system is supplied separately to the boiler and must be specified at the point of order - refer to
Appendix C.
Warranty
Full warranty assistance will be covered when the appliance is commissioned by Hamworthy Heating Ltd, see
Terms & Conditions for full details.
Hamworthy Heating Ltd will not accept any liability resulting from damage due to tampering, improper
use, handling, installation errors, operation and maintenance. It is important to check for damage upon
receipt of product, which if found must be notified to Hamworthy Heating Ltd immediately.
In the event of failure or breakdown, isolate the equipment and contact Hamworthy Technical Support
Tel - 0845 450 2866
Figure 2.1 - Boiler Packaging
W
H
D
To Next Page
Loading...
