What does it mean when the ON/OFF light flashes four times on my Handicare PUMA 40 Wheelchair?
If the ON/OFF light flashes four times, it means that either the connection of the m2 motor is faulty or the m2 motor is defective. Check the motor connections and cabling. If the problem persists, replace the m2 motor.
What does it mean when the ON/OFF light flashes 11 times on my Handicare PUMA 40 Wheelchair?
If the ON/OFF light flashes 11 times on your Handicare Wheelchair, it indicates a 'STALL' overload fault, meaning a motor is continually demanding too much power. Check the drive units. This fault is often caused by obstacles that are too high, or driving against walls and door frames, etc. It may also be caused by a difficult turn from a standing position.
What does it mean when the service indicator flashes twice and the ON/OFF light flashes three times on a Handicare Wheelchair?
This indicates a battery fault or a defective M1 motor. Check the batteries and cabling, charge or replace the batteries, and check the motor connections and cabling. If the issue persists, the M1 motor may need to be replaced.
What does 'Right Lamp Short' mean on my Handicare PUMA 40 Wheelchair and how do I fix it?
A 'Right Lamp Short' means the control system has detected a short in either of the Lamp Circuits. Check the lamps, cables, and connections to the control system. If the error persists, the ISM may be defective.
What does 'DIME Error' mean on my Handicare PUMA 40 Wheelchair and how can I fix it?
A 'DIME Error' indicates an identification conflict between two modules in the system. If a new module has been introduced: Disconnect the new module and cycle the power. If no error is present, connect the new module to the system and cycle the power. If the error reappears, the new module is the cause. If there have been no additions: Disconnect one module at a time and cycle the power.
What to do if my Handicare Scooter ON/OFF light doesn't turn on and the wheelchair won't move?
If the ON/OFF light doesn't illuminate and the Handicare Scooter remains stationary, consider these potential causes and solutions: * Ensure the controller plug is correctly inserted into the power module. It may be a stall timeout, place the joystick in neutral and try again. * Inspect the fuses and replace any that are defective. * Verify that the batteries are properly connected. * Check for loose battery connections and secure them.
What does System Error mean on my Handicare Scooter?
The 'System Error' message on your Handicare Scooter indicates a trip that cannot be attributed to a specific module. Check all cables and connections and cycle the power. If the system contains 3rd party Modules, disconnect all the none PGDT modules and cycle the power.
What does PM Memory Error mean on my Handicare Scooter?
A PM Memory Error on your Handicare Scooter is a specific Power Module based trip. Check all cables and connections.
What does it mean if ON/OFF light flashes once on Handicare Mobility Aid?
If the ON/OFF light on your Handicare Mobility Aid flashes once, it indicates a faulty DX module. Replace one or more modules. The 'on/off' LED indicates the condition of the entire system, while each module has a separate status LED to help identify the faulty one.
How to fix service indicator flashes once on Handicare Mobility Aid?
If the service indicator flashes once on your Handicare Mobility Aid, it's likely a 'STALL' timeout due to user error. Place the joystick in neutral and try again.
General| Brand | Handicare |
|---|---|
| Model | PUMA 40 |
| Category | Wheelchair |
| Language | English |
To Next Page
