Why does my Handicare Wheelchair show a low battery error?
A low battery error on your Handicare Wheelchair indicates that the control system has detected a battery voltage below 16V. Check the condition of the batteries and their connections to the control system. If the error persists after checking the batteries and connections, the Power Module may be defective.
What to do if my Handicare Wheelchair ON/OFF light doesn't turn on and it won't move?
If the ON/OFF light doesn't illuminate and the wheelchair remains stationary, several factors could be at play. First, ensure the controller plug is correctly inserted into the power module. Additionally, inspect the fuses and replace any that are defective. Verify that the batteries are properly connected and that all connections are secure. If this is a 'STALL' timeout, place the joystick in neutral and try again.
What does it mean if ON/OFF light flashes once on Handicare Mobility Aid?
If the ON/OFF light on your Handicare Mobility Aid flashes once, it indicates a faulty DX module. Replace one or more modules. The 'on/off' LED indicates the condition of the entire system, while each module has a separate status LED to help identify the faulty one.
How to fix service indicator flashes once on Handicare Mobility Aid?
If the service indicator flashes once on your Handicare Mobility Aid, it's likely a 'STALL' timeout due to user error. Place the joystick in neutral and try again.
What to do if service indicator flashes twice and ON/OFF light flashes three times on Handicare Mobility Aid?
If the service indicator flashes twice and the ON/OFF light flashes three times on your Handicare Mobility Aid, it could indicate a battery fault. Check the batteries and cabling, and try charging or replacing the batteries. Also, inspect the motor connections and cabling. Alternatively, the m1 motor may be defective, requiring replacement.
How to fix a Joystick Calibration Error on a Handicare PUMA 40?
A Joystick Calibration Error indicates that the Joystick Calibration process was unsuccessful. Enter OBP and attempt calibration. If the error persists, the Joystick Module may be defective.
What to do if my Handicare Scooter ON/OFF light doesn't turn on and the wheelchair won't move?
If the ON/OFF light doesn't illuminate and the Handicare Scooter remains stationary, consider these potential causes and solutions: * Ensure the controller plug is correctly inserted into the power module. It may be a stall timeout, place the joystick in neutral and try again. * Inspect the fuses and replace any that are defective. * Verify that the batteries are properly connected. * Check for loose battery connections and secure them.
What does it mean when the ON/OFF light flashes twice on my Handicare Wheelchair?
If the ON/OFF light flashes twice, it could mean the DX accessory is faulty due to a programming fault or short circuit/overload of the accessories. Alternatively, if the electrical high/low adjustment is not in the lowest position, the LED will flash twice to indicate that the speed limitation has been switched on, causing the wheelchair to drive more slowly.
What does it mean when the ON/OFF light flashes once on my Handicare Wheelchair?
If the ON/OFF light flashes once, it indicates that the DX module is faulty. Replace one or more modules. The 'on/off' LED indicates the condition of the entire system. The modules all have a separate status LED: in this way, you can see which one is faulty.
What should I do if my Handicare PUMA 40 Wheelchair displays 'Charging' as an error?
If an On-Board Charger is used: Disconnect the charger from the AC supply. If an Off-Board Charger is used: Disconnect the charger from the Wheelchair. If the trip is still present after the charger has been disconnected then the Joystick Module may be defective.
General| Brand | Handicare |
|---|---|
| Model | PUMA 40 |
| Category | Wheelchair |
| Language | English |
To Next Page
