Tedder was not damaged in shipment. Check for dents and loose or missing parts. Report
damage immediately to H&S Manufacturing Co., Inc.
Tedder has been correctly assembled according to instructions in this manual. Wheel nuts
and all other fasteners are tightly secured.
All bolts and fasteners are tight.
All grease fittings have been lubricated. See Lubrication Chapter of this manual for details.
PTO Shields slide freely.
All Shields and Guards are in place and fastened.
All mechanisms are operating trouble free.
Belts are properly adjusted.
Tires are inflated to correct pressure.
Decals are in place and legible.
After the Tedder has been completely set-up, check to be certain it is in correct operating order before
delivering to the customer. The following is a list of points to inspect. Check off each item as you
have made the proper adjustments and found the item operating satisfactorily.
Serial Number
Dealer’s Name
Signature of Pre-Delivery Inspector
-5-
(Remove Dealers File Copy At Perforation)
DEALER PRE-DELIVERY CHECK LIST
AFTER COMPLETION, DEALER SHOULD REMOVE AND RETAIN FOR RECORDS
Inspection Date
Model Number
To Next Page
Loading...
