HANGCHA CPQD15N-RW21 - Technique Parameter of LPG Special for Vehicle

88
Table 1 technique parameter of LPG special for vehicle
Quality parameter
Item component com
position
1#
2# 3#
Trial
37.8℃ vapour (indication)
k Pa
≤1430
890～1430 660～1340 GB/T 6602
a
propane
＞85
＞65～85 40～65
Butane and advanced
≤2.5
— —
Pentane and advanced
—
≤2.0 ≤2.0
alkene
≤10
≤10 ≤10
Component %
Butadiene
（1,3butadiene ）
≤0.5
≤0.5 ≤0.5
SH/T 0614
b
100ml remainder after
evaporation ml
≤0.05
≤0.05 ≤0.05
remainder
Observe soiled-oil
pass
pass pass
SY/T 7509
density（20℃ ） kg/m
3
actually
measure
actually
measure
actually
measure
SH/T 0221
c
Sheet copper corrosion
≤1
≤1 ≤1 SH/T 0232
Total sulfur content /(mg/m
3
)
＜270
＜270 ＜270 SH/T 0222
d
sulphuretted hydrogen zero zero zero SH/T 0125
free water zero zero zero Eyeballing
1： gaseity content , total sulfur content is at 0℃、101.35kPa.
2：can measure sample whether it exists free water by eyeballing when measuring density.
a
evaporation pressure can be evaluated by GB/T 12576， measured by GB/T 6602 when arbitration。
b
component can be measured by SH/T 0230，but measure by SH/T 0614 when arbitration.
c
density can be measured by GB/T 12576,but measured by SH/T 0221 when arbitration.
d
Total sulfur content can be measured by SY/T 7508，but measured by SH/T 0222 when arbitration.
From : PRC STANDARD 《LPG IN VEHICLE》（GB 19159-2003）