21
PC & STORAGE INTERFACE
Logged data on edge
® DO
can be transferred from the meter to a USB flash drive by using the log
recall function. The minimum requirement for the drive is USB 2.0. Select the DO record you wish to
export and follow the simple steps below.
Connect USB flash drive to the USB port, located on the top of the
meter. Press the RCL key. Select Manual, Stability, or interval lots by
using the keys. Press the LOG key (not GLP/CFM). The “USB
HOST” tag should come on.
“PLEASE WAIT” message appears followed by “EXPORT”.
Press GLP/CFM key to export the selected record or lot. If GLP/CFM
key is not pressed in 10 seconds, the USB host will become inactive.
The meter will display the percentage of export.
The export percentage should go to 100%. Remove USB flash drive.
If the selected file is already saved on the flash drive, edge
® DO
will ask for
confirmation of overwriting the existing file. The message “OVERWRITE’
and “CFM” tag will blink. Press GLP/CFM key for overwriting the
existing file or CAL/MODIFY key to exit without exporting.
After exporting the display will return to the selected file. Press the RCL
key twice to return to measurements.
Note: Do not remove USB flash drive during an active export
transfer.
SETUP/INSTALLATION
To Next Page
Loading...
