10
SETUP/INSTALLATION
SETTING UP edge
® DO
The main operating modes of edge
® DO
are setup, calibration, measurement, data logging, and data
export. Follow this general outline of steps to get you started. The following topics are expanded upon
in the sections that follow in this manual.
1. Familiarize yourself with the design features of this unique meter.
2. Decide how the meter will be used and set up the wall or bench cradle in a clean area near
line power.
3. Turn edge
® DO
on using the ON/OFF button located on the top of the meter.
4. Plug in the probe required for measurement.
5. SETUP the measurement parameters required for the measurement you will be making.
6. Calibrate the sensor/probe.
You are now ready for measurements.
Bench Cradle Setup
Insert electrode holder arm into the post on the pivoting base.
Connect the probe connector to the socket located at the bottom of the instrument.
To Next Page
Loading...
