20
Press GLP/CFM key. The instrument will display “PLEASE WAIT” and then “CLEAR DONE” message.
When individual logs are deleted within saved MANUAL or STABILITY logs, the logs will renumber,
filling in the deleted data but staying in chronological order.
To delete all records of the MANUAL (STABILITY) log, proceed as described on page 19 for LOTS.
Select the Manual (Stability) lot and press SETUP/CLR key. The
”CLEAR” message will be displayed along with ”MANUAL” or
“STABILITY” and CFM tag blinking on the LCD. Press the GLP/CFM key
to confirm the deleting of the selected lot (MANUAL or STABILITY) or all
records. Press SETUP/CLR key to exit without deleting.
The lot number is used to identify particular sets of data. The lot numbers are allocated successively
until 100, even if some lots were deleted. The total number of lots that can be saved is 100. If
some are deleted (for example 1‑50), fifty additional logs may be stored. These will be numbered
101‑150. The lots are allocated successively (provided available memory space) until 999 is reached.
After this, it is necessary to delete all the LOT logs to start over the numbering.
Delete All
All logs, may be deleted in a single clear. This function will delete all MANUAL, STABILITY and
INTERVAL logs.
Press the RCL key. The DO type will be blinking. Use RANGE/u key to
select desired measurement parameter log data to delete.
While the measurement type is blinking and message states “LOG
RECALL”, press SETUP/CLR key.
“CLEAR ALL” and measurement type will be displayed with “CFM” tag
blinking. Press GLP/CFM key.
“PLEASE WAIT” and the percent cleared will be displayed until
completed. The procedure can be repeated for the other measurement
modes.
Note: If SETUP/CLR key is pressed in error, press SETUP/CLR key
again to exit without deleting.
SETUP/INSTALLATION
To Next Page
Loading...
