57
Press <Info> to view the GPS coordinates of the selected location. Press <Delete> to erase the
selected location.
Press <New> to add a new location. Coordinates for a new
location can be entered manually or by using the current GPS
coordinates.
Clear all locations
This option deletes all locations. The meter will ask for confirma‑
tion before proceeding, by displaying the message “All location
information will be erased. Continue?”.
Press <Yes> to confirm deletion or <No> to return to the
previous screen.
GPS power save
This feature saves battery life by automatically switching the GPS
unit off when the meter is in continuous logging mode with a
logging interval of at least 4 minutes. The GPS unit will turn off
after each measurement and turn on again 3 minutes before
the next measurement is taken.
If the GPS unit cannot obtain a position fix within two minutes,
it will keep the GPS on by disabling the power save feature.
GPS status
This screen displays the following GPS information: latitude and
longitude of the current position, number of acquired satellites,
time elapsed since last detected position (if the GPS signal is
not currently available).
Pressing <GPS OFF> will disable the GPS unit.
Pressing <GPS ON> will enable the GPS unit and show the
GPS receiver model and version.
Since the power consumption of the GPS unit is significant, it
is recommended to turn the GPS unit off when it is not needed.
GPS MENU
To Next Page
Loading...
