66
One Sample On Meter
Use this option to log one set of enabled measurement
parameters to the meter memory.
• If there are no lots saved on the meter, press <New> to
create a new lot. Use the keypad to enter the desired lot
name and press <Accept> to confirm. Press <OK> to
log the sample in the selected lot.
• If there are existing lots on the meter, the meter will suggest
a lot to store the sample. Press <OK> to use the selected
lot or <Options> to select a different lot. This will add
the new sample data to an existing lot. A new lot can also
be created by pressing <New>. Press <OK> to log
the sample in the selected lot.
• On the “Remarks” window, select <Yes> to go to the
Remarks screen. Press <No> to skip this option. If
<Yes> is selected, select a remark from the list, or press
<New> to create a new remark.
• On the “Read tag” screen, touch the location’s iButton
®
with the meter’s tag reader. Otherwise, press <Skip>
to skip this option. Up to 20 tags can be used in a single
log file.
• If the tag is touched, the associated ID will be displayed. If
no ID is associated to the tag, the serial number is shown.
• Press <Modify> to insert an identification code for the tag, then press <OK>.
• To return to the measurement screen, press ESC.
LOGGING ON METER
To Next Page
Loading...
