3
PRELIMINARY EXAMINATIONPRELIMINARY EXAMINATION
PRELIMINARY EXAMINATIONPRELIMINARY EXAMINATION
PRELIMINARY EXAMINATION
The Hanna pH 210, pH 211, pH 212 and pH 213 are micropro-
cessor-based bench meters for pH and temperature measurements.
pH 211 and pH 213 can also measure ion concentration (ISE) and
ORP (Oxidation Reduction Potential) in the mV range.
The pH measurements are compensated for temperature effect manu-
ally or automatically with the HI 7669/2W temperature probe.
The meter comes equipped with a large easy-to-read LCD which shows
the pH (or mV) and temperature simultaneously together with graphic
symbols.
The calibration process is guided step by step through clear indications
on the LCD. A stability indicator make the calibration procedure error-
free.
Through the RS 232C serial port you can transfer the data to a PC
(pH 212 and pH 213 only).
GENERAL DESCRIPTIONGENERAL DESCRIPTION
GENERAL DESCRIPTIONGENERAL DESCRIPTION
GENERAL DESCRIPTION
Remove the instrument from the packing material and examine it
carefully to make sure that no damage has occurred during shipping.
If there is any damage, notify your Dealer or the nearest Hanna
Custumer Service Center.
Each meter comes supplied complete with:
• HI 1131B glass-body combination pH Electrode with 1 m
(3.3') cable
• HI 7669/2W Temperature Probe
• HI 76404 Electrode Holder
• pH 4.01 & 7.01 Buffer Solutions (20mL each)
• HI 7071S Electrolyte Solution
• 12VDC Power Adapter
• Instruction Manual
Note: Save all packing material until you are sure that the
instrument functions correctly. All defective item must be
returned in the original packing with the supplied accessories.
30
WARRANTYWARRANTY
WARRANTYWARRANTY
WARRANTY
All Hanna Instruments meters are guaranteed for two years against
defects in workmanship and materials when used for their intended
purpose and maintained according to instructions. The electrodes
and the probes are guaranteed for a period of six months. This
warranty is limited to repair or replacement free of charge.
Damage due to accident, misuse, tampering or lack of prescribed
maintenance are not covered.
If service is required, contact the dealer from whom you purchased the
instrument. If under warranty, report the model number, date of
purchase, serial number and the nature of the failure. If the repair is
not covered by the warranty, you will be notified of the charges
incurred. If the instrument is to be returned to Hanna Instruments, first
obtain a Returned Goods Authorization number from the Customer
Service department and then send it with shipping costs prepaid.
When shipping any instrument, make sure it is properly packaged for
complete protection.
To validate your warranty, fill out and return the enclosed warranty
card within 14 days from the date of purchase.
All rights are reserved. Reproduction in whole or in part is prohibited
without the written consent of the copyright owner,
Hanna Instruments Inc., 584 Park East Drive, Woonsocket, Rhode
Island, 02895 , USA.
Hanna Instruments reserves the right to modify the design, con-
struction and appearance of its products without advance notice.
To Next Page
Loading...
Need help?
General
