Hanover DG3 - 3.5.1 Status options

DG3 Controller – Installation and Operation
Manual
540846-3 page 26 of 64 25/09/2015
However, manual changes to those parameters can then be made directly via the controller itself if required.
Note that any such changes will then be overwritten by a future download from Helen.
The functions are arranged hierarchically: in its normal operating mode, the controller shows level 1. The
table below shows how to navigate to the other functions. The left arrow acts as the 'back' key.
1st level
2nd level
3rd level
Reach this list
by pressing
the F/E key
 Reach this list by keying in the lock
code and using the F/E key.
 Navigate through this list by using the
up / down arrow keys
 Reach an option in this list by using
the F/E key
 Navigate through the option list by
using the up / down keys
 Reach an option in this list by using
the F/E key
 To change this option, navigate
through the list by using the up /
down arrow keys and using the F/E
key
Lock code:
Show status?
3.5.1 Status options
Test signs?
3.5.2 Running the signs test
Configure?
3.5.3 Configuration options
System?
3.5.4 System options
Ports?
3.5.5 Port options
Signs?
3.5.6 Sign options
Dump data?
3.5.7 Dump data screen sequence
HANCIS
3.5.8 HANCIS
Set clock?
3.5.9 Setting the clock
Back
Status options
This option provides access to information about the status and configuration of the controller and the
signs connected to it. The two ways to access this option are:
 either by holding down the F/E key for about 3 seconds. The HANCIS menu will be displayed first if
connected. Then, press the up arrow key to access the status option.
 or by entering the lock code. 'Show status?' can be found from within the list and then selected using
the F/E key. Use the up and down arrow keys to navigate between each one.
Note: If accessing the status options by holding down the F/E key, the status options screen will be
displayed temporarily (only for a few seconds) and the DG3 will revert to its previous state. Whereas via
the lock code, the status options screen will remain displayed until the user presses on the left arrow key
or F/E key to quit this option.
The 4-digit lock code is 0101 by default.
If any changes have been made in the settings of the DG3, the controller will prompt for
confirmation. If there is no confirmation of the changes after a set period of time, the
controller will save the changes (by default) and then revert to the last destination
programmed.