Getting startedSeite GB-24
NOTICE
Risk of damage!
If the cooling unit has been transport-
ed horizontally, lubricant from the com-
pressor may get into the cooling circuit.
■ Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
• Insert the mains plug into an easily ac-
cessible and properly installed socket
(220–240 V~ / 50 Hz).
When the door is open, the interior light-
ing will now be switched on.
You will find all important information
about operation from page GB-10.
To Next Page
Loading...
