Getting started
Seite GB-23
Carefully wedge the blanking plates into the
top of the door.
30. Check whether the door seal is intact
all the way round. To test, clamp a thin
piece of paper in various places. The
paper should be difficult to pull through
at all places.
31. If the seal is not uniform everywhere:
Carefully warm the seal at the corre-
sponding places with a hair dryer and
pull out a little with your fingers.
Cleaning before use
To remove the odour that comes with all new
appliances, clean the appliance before us-
ing it (see "Care and maintenance“ on page
GB-16).
Commissioning the appliance
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
■ Do not operate or continue to oper-
ate the appliance, if
– it shows visible signs of damage,
e.g. the power cord is defective,
– it starts smoking or there is a smell
of burning,
– it makes unfamiliar noises.
In such cases, pull out the mains plug
or unscrew/isolate the fuse and con-
tact our service department (see page
GB-27).
■ Do not connect to a timer or a sepa-
rate remote-controlled system for dis-
tance monitoring and control.
■ If the mains plug is no longer acces-
sible after installation, an all-pole dis-
connecting device complying with
overvoltage category III must be
connected to the house wiring with a
contact gap of at least 3 mm; this in-
cludes fuses, circuit breakers and con-
tactors.
■ Do not kink or pinch the mains cord
or lay it over sharp edges. This can re-
sult in a break in the cable.
CAUTION
Fire hazard!
Improper handling of the appliance
can lead to fi re and property damage.
■ Only connect the appliance to a
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
To Next Page
Loading...
