Hanseatic HTW8013C User Manual

Page EN-31
Installation, connection and initial commissioning
– The ground must be secure, even, clean
and dry.
– It is not appropriate to have a rug or car-
pet under the appliance, as the appliance
will not be ventilated well enough and can
overheat.
For use on rugs, carpets, parquet or wood-
en floorboards, place a stable wooden
board underneath the appliance (measur-
ing at least 40 × 60 cm).
If it is placed on a wooden plate or base,
the screw-on feet should be fixed so that
the appliance does not dislodge itself when
spinning.
Lay a smooth tiled floor or rubber mat un-
der the screw-on feet.
Aligning the appliance
(31)
(21)
1. Loosen the lock nut (31) of one of the screw-
on feet (21) underneath the appliance.
2. Using your hand, screw the foot (21) in
or out as far as necessary. To adjust the
foot, twist it
– anti-clockwise to unscrew.
– clockwise to screw in.
3. Repeat this for the other screw-on feet
until the appliance is standing completely
horizontally and securely.
4. Twist the lock nuts of all screw-on feet
upwards to the underside of the machine
and tighten the lock nut against the un-
derside of the machine.
Water connection
Establish drain for water
WARNING
Risk of scalding!
Improper handling of the appliance
can lead to scalding caused by hot suds.
■ Fix the hose to the sink or bath to pre-
vent it from slipping due to the recoil
caused by pumping.
■ For drains, make sure that the
cross-section of the discharge pipe is
great enough that the drain cannot
overfl ow.
NOTICE
Risk of damage to property!
Improper handling of the appliance
can lead to water damage.
■ Use only the water outlet hose pro-
vided.
■ Do not extend the water outlet hose
or replace it with another hose.
■ The water outlet hose must not get
bent or twisted.
■ The curvature of the water outlet hose
must be at least between 60cm and
100 cm above the ground to ensure
the water drain functions perfectly.
■ The water outlet hose must be in the
retaining clips on the back of the ap-
pliance so that the bend on the hose
always remains above the waterline
inside the appliance. The end of the
hose must not be submerged in the
pumped water.

Hanseatic HTW8013C Specifications

General

Brand	Hanseatic
Model	HTW8013C
Category	Washer
Language	English