OperationPage GB-16
position, and wind the mains
cord around the upper (5) and
lower (10) mains cord holders.
(1)
4. Snap the vacuum body back
into the upright position.
Using the turbo brush
(4)
• To use the turbo brush,
press the selector button (4).
(14)
The indicator light (14) illumi-
nates blue.
• To switch the turbo brush off,
press the selector button (4)
again. The indicator light (14)
goes out.
The turbo brush does not
switch off automatically
when the appliance is switched
off. To switch off the turbo brush
once you have finished vacuum-
ing, snap the vacuum body back
into the upright position as de-
scribed in Section „Finishing vac-
uuming“ on page GB-15.
Using the 3-in-1 tool
The 3-in-1 tool is used in con-
junction with the suction hose (7).
To Next Page
Loading...
