Hantek HDG 2000 Series - Calibration and IEEE-488 Commands

Appendix
HDG2000 Series Arbitrary Waveform Generator
101
Remote Interface Configuration
SYSTem:BEEPer:STATe ON|OFF
SYSTem:BEEPer
SYSTem:LANGuage ENGLish|SCHinese，SYSTem:LANGuage?
SYSTem:KLOCk ON|OFF
SYSTem:KLOCk?
SYSTem:COMMunicate:LAN:GATEway <address>
SYSTem:COMMunicate:LAN:GATEway?
SYSTem:COMMunicate:LAN:IPADdress <ip_addr>
SYSTem:COMMunicate:LAN:IPADdress?
SYSTem:COMMunicate:LAN:SMASk <mask>
SYSTem:COMMunicate:LAN:SMASk?
SYSTem:COMMunicate:LAN:MAC?
SYSTem:ERRor?
SYSTem:ROSCillator:SOURce INTernal|EXTernal
SYSTem:ROSCillator:SOURce?
SYSTem:VERSion?
DISPlay:BRIGhtness <brightness>|MINimum|MAXimum
DISPlay:BRIGhtness? [MINimum|MAXimum]
DISPlay:SAVer ON|OFF
DISPlay:SAVer ?
Phase-Lock
SOURce<n>:PHASe <phase>|MINimum|MAXimum
SOURce<n>:PHASe? [MINimum|MAXimum]
SOURce<n>:PHASe:SYNChronize
Counter
COUNter ON|OFF
COUNter:MEASure?
COUNter:GATEtime UTO|USER1|USER2|USER3|USER4|USER5|USER6
:COUNter:GATEtime?
COUNter:TYPE LFCOUNTER|LFFREQ|HFCOUNTER|HFFREQ
Calibration
CALibration:SETup <step>
CALibration?