Need help?Do you have a question about the Hantek HDG 2000 Series and is the answer not in the manual?
Overview of the Hantek HDG2000 Series waveform generators and their capabilities.
Detailed description of the front panel layout and its interactive areas.
Details on the connectors and interfaces available on the rear panel.
Basic procedures for connecting and powering on the instrument.
Explains the front-panel menus and their functions for waveform generation.
Covers system settings, information, state, updates, counter, self-test, and calibration.
Procedures for saving and loading instrument configurations and states.
Information on communicating with the instrument via PC using USB port.
Details on configuring output channels, waveforms, and modulation compatibility.
Parameters and settings for generating pulse waveforms.
Configuration for Amplitude (AM) and Frequency (FM) modulation.
Configuration and parameters for Phase Modulation (PM).
Settings for Frequency-Shift Keying (FSK) modulation.
Configuration and parameters for Pulse Width Modulation (PWM).
Details on setting up and performing frequency sweeps.
How to configure and use the burst mode for waveform output.
Explanation of the instrument's triggering system for sweeps and bursts.
Step-by-step guides for generating Sine, Square, Ramp, Pulse, Noise, Arb, and Harmonic waves.
Describes the two methods for inputting parameters using the front panel.
Explanation of waveform modes like AM, FM, PM, ASK, FSK, PSK, PWM, BPSK.
Instructions for using the digital generator and its programmable signals.
Explains SCPI syntax conventions, symbols, and structure.
Reference for major SCPI subsystems like AM, FREQuency, FUNCtion, OUTPut, SYSTem, VOLTage.
Practical examples for common programming tasks like configuring waveforms.
Reference for SCPI commands related to data handling and waveform functions.
SCPI commands for managing output, sync signals, and general control.
SCPI commands for various modulation types like AM, FM, PM, FSK, PWM.
SCPI commands for sweep, burst mode, and trigger system control.
SCPI commands for system settings, memory, and remote interface configuration.
SCPI commands for calibration procedures and IEEE-488 common commands.
Details on different HDG2000 models and their main features.
Specifications for frequency ranges and performance of various waveforms.
Specifications related to amplitude, offset, and modulation parameters.
Covers display, power, weight, interfaces, and overall system specifications.
To Next Page
General
