Timer Action of Exclusive Indication (GE-T)
Power RUN - ON delay
Maintains the indication of initial value when Power is ‘ON’
Run when there is START (CP2) input
OFF Output for SET1 Time / ON for SET2 Time. Repetition
Initializes and stops when Reset is ‘ON’
Runs when START (CP2) is ‘ON’, and resets when START (CP2) is ‘OFF’
Set Time is first to be reduced during Down Mode Setup.
Maintains the indication of initial value when Power is ‘ON’
Runs with the input of Start (CP2)
Output ON for SET1 time/repeat OFF for SET 2 times
Initializes and stops when Reset is’ON’
Individual output control and setup pauce time
RUN when power is ON
Output OUT1 during SET1 time and OUT1 OFF during pause time
Output OUT2 during SET2 time and OUT2 OFF during pause time
and operations repeated
t: Possible to set up from 0 to 99.99 sec with pause time setting
Runs after initializing the process value upon the authorization of Run Reset
Signal when Power is ‘ON’ Set Time is first to be reduced during Down Mode
Setup.
OFF set is available for up time range of Decimal system.(Press key for 2
second)
Runs when Power is ‘ON’
ON Output for T1 Time / OFF for T2 Time. Repetition
Initializes and stops when Reset is ‘ON’
Signal START - ON delay
Signal RUN
Signal START - ON delay
Power RUN / OFF time
Power RUN
1. Press key
Enter to setup state, 6 rows (4rows) FND flickers, set "100" by pressing
/ key (When use want to set 100 batch.)
2. Pressing key will complete setup. (Pressing key will exit without
changing)
3. Pressing key will return to operation mode. (Left side BAT lamp off)
Properly operates within BATCH display mode
Possible to setup BAT only with , BAT setting.
Batch Counting & Output Action
Batch counting value continues to increase until Batch Reset is authorized.
When batch coefficient value exceeds 999999 (4 rows 9999), it initializes to
0 and display
In case of batch display state (BAT lamp is lighted), press the key on
the front section to reset the batch value.
Even in the batch display state, counter/timer action operates normally.
Batch coefficient increases at the output of OUT2 (OUT).
Batch output is outputted as (BAT.O). (BAT.O lamp is lighted)
Instant Output Setup
Function switches over to instant output when the batch value is set at 0.
(BAT.O lamp is lighted)
Batch Counter setup Method
Batch Counter
To Previous Page
Loading...
