EasyManua.ls Logo

HANYOUNG NUX TD300 - Installation Method; Installation Place and Caution Notice

HANYOUNG NUX TD300
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
2 Installation method
This is information for installation place and method of TD500 (2 loop temperature controller). So please
ready it before installation.
2.1 Installation place and caution notice
2.1.1 Installation place
To avoid electric shock, please use it after installation to panel
Please avoid installing the product for following places where
People can touch terminal unconsciously
Directly exposed to the mechanical vibration or impact
Exposed to the corrosive gas or combustible gas
It is exposed to mechanical shock or vibration
Danger of corrosion or combustion of gas exist
Temperature changes too frequently
Temperature is either too high or too low
It is exposed to direct rays
It is exposed to electromagnetic waves too much
Humid place
It has many combustible objects
It has dusts and salinity
2.1.2 Caution
The case of this controller is chrome-zinc plating and Bezel is made by ABS/PC anti-combustion
material but please not install it to the inflammable place. Especially please do not put it on the
inflammable products.
Please keep it away from the machine or wires that can be cause of noise.
Especially, please have enough warn-up when you operate it under 10 ℃ temperature.
Please install it on horizontally
When you wire it, please cut out all of electric power.
This controller is operating in 100 - 240 V AC, 50-60 Hz without additional change.
If you use other voltage, it may case of fire and electric shock.
Do not operate controller with wet hand, it may cause of electric shock.
Please follow Safety Information to prevent any fire, electric shock and any damage.
Please follow this manual for install and operation of this controller.
When you put to earth, please refer to install method. But do not it earth to gas pipes, phone lines
and lightning rods
Please do not turn on power until you install all of parts
Please do not block ventilating windows. It may cause of break down.
The grade of over voltage is Catalogue and using environment is Degree
هﺮﮐ ﮓﻧﺎﯿﻧﺎﻫ تﻻﻮﺼﺤﻣ یرﺎﺼﺤﻧا هﺪﻨﯾﺎ ناﻮﯿﺳ ﺖﮐﴍ
021-33989001
www.sivancarno.com
021-33989002

Related product manuals