Need help?Do you have a question about the HANYOUNG NUX TD510 Series and is the answer not in the manual?
General| Model | TD510 Series |
|---|---|
| Sampling Cycle | 100ms |
| Input Type | Thermocouple, RTD |
| Output Type | Relay, Current |
| Power Supply | 100-240 VAC 50/60Hz, 24 VDC |
| Control Method | PID control |
| Communication | RS485 (optional) |
| Accuracy | ±0.3% FS |
| Operating Temperature | 0 to 50°C |
| Storage Temperature | -20 to 60°C |
Understand and follow safety guidelines to prevent injury and damage.
Guidelines for selecting an appropriate installation location and environmental precautions.
Step-by-step instructions for mounting the device and connecting components.
Instructions for connecting power, FG, relay outputs, and input signals safely.
Visual representation of terminal assignments for display, power, and communication modules.
Configuration options for control modes, fuzzy logic, tags, and time settings.
Procedure for updating the device firmware and navigating the upgrade interface.
Creating and editing program patterns, including segment values and timing.
Procedure to access system settings, including password requirements and warnings.
Configuring sensor types, ranges, decimal points, filters, and display units.
Setting control modes, output cycles, types, and transmission output parameters.
Configuring PID zone selection, control types, auto-tuning gain, and hysteresis.
To Next Page
