HANYOUNG NUX TD510 Series - Control and Transmission Output Settings

Programmable Temperature & Humidity Controller
54
1. Sensor type
- Select a sensor type. It can't be changed when it is being saved.
- If the type of sensor is changed, related parameters(use range) are initialized so set the type of
sensor first.
2. Use range
- Enter range values to use. It can't be changed when it is being saved.
3. Position of decimal point
- If the sensor is DCV, define the position of decimal point. It can't be changed when it is being saved.
- If the sensor is RTD or TC, the position of decimal point is already fixed.
4. Input filter
- Enter a digital filter value of input.
5. Display unit
- Set the display unit. (℃, Ω, V, mV, %, or User-define)
- Select User-define to enter user-defined unit. It can't be changed when it is being saved.
▶ Input setting
1. Sensor input setting
1. DCV input upper/lower limit
- If the sensor is DCV, define the input value of DC voltage. It can't be changed when it is being saved.
Fig. 79) Ch.1 sensor setting(TC-K)
Fig. 81) Ch.2 sensor setting(DCV)
Fig. 80) Ch.1 sensor change
Fig. 82) Ch.2 sensor change