61
Installation
Before starting
Operation
Screen block
diagram
Function setting Program System setting Specifications
Start of control
Wider proportional band
(faster response and hunting)
Wider proportional band
(slower response and large offset)
Offset
Time
Offset
Proportional control
Time
Proportional
+
Integral control (PI)
Short integral time
Long integral time
- Set target, range direction, and type of individual inner signals.
- Up to 16 inner signals can be set
▶ Inner signal setting
4. Inner signal
1. Target setting
- Set a target of inner signal.
2. Range direction
- Set the operation range of temperature to use inner signal.
3. Type
- Set a target of inner signal to apply.
- T.S.V : Based on target setting value
- N.S.V : Based on current measurement
- P.V1 : Based on operation range L and H for measurement
- P.V2 : Based on setting values and their offset setting values
Fig. 94) ON/OFF control
Fig. 96) Proportional/Proportional,
Integral control(P control/P.I) control
Fig. 95) Proportional control (P control)
Fig. 97) Proportional integral control (P.I control)
Fig. 98) Inner signal
To Next Page
Loading...
