19
Installation
Before starting
Operation
Screen block
diagram
Function setting Program System setting Specifications
▶ Concurrent control
1. Operation screen
1-1. Constant-value operation screen
1) Constant-value operation 1 screen
- Constant-value/program operation may be changed in [Main menu] - [Operation setting] - [Operation setting].
- Start and end of operation may be run in the operation screen 1 and 2.
- Concurrent/individual operation may be changed in [Main menu] – [System menu] – [System] – [Memory&Specifications].
- Press Run button in the center left of stop screen of constant-value screen 1 in order to switch to the constant-value
operation 1 operation screen.
Fig. 9) Stop screen of constant-value operation screen 1(Concurrent control)
Fig. 10) Operation screen of constant-value operation screen 1(Concurrent control)
No. Description
1 Displays state of SD card.
2 Runs hidden menu pane. Click the same to hide menu pane.
3 Go to operation 2 screen.
4 Go to main menu screen.
5 Displays temperature measurement(PV).
6 Displays unit of channel 1.
7 Displays heating control output(H.MV) of channel 1. (For heating/cooling control)
8 Displays cooling control output(C.MV) of channel 1. (For heating/cooling control)
9 Enter target setting value(TSV) for channel 1.
10 Enter current setting value(NSV) for channel 1. (Displayed during operation only).
11 Displays ascending/descending/holding state of channel 1.
12 Displays measurement(PV) of channel 2.
13 Displays unit of channel 2.
14 Displays heating control output(H.MV) of channel 2. (For heating/cooling control)
15 Displays cooling control output(C.MV) of channel 2. (For heating/cooling control)
16 Enter target setting value(TSV) for channel 2.
17 Enter current setting value(NSV) for channel 2. (Displayed during operation only).
18 Displays ascending/descending/holding state of channel 2.
19 Run/stop button.
20 Displays general operation state messages.
21 Displays operation time.
②
⑩
⑦
③ ④
⑫
⑯
⑱⑳ ㉑
⑲
⑬
①
⑥
⑤
⑪
⑰
⑧
⑭
⑨
⑮
To Next Page
Loading...
