HANYOUNG NUX TD510 Series - Pattern Name Setting

49
Installation
Before starting
Operation
Screen block
diagram
Function setting Program System setting Specifications
▶ Copy/Delete
1) Select an original pattern.
2) Select a target pattern.
3) Copy the pattern.
4) Select a patter No. to delete.
5) Delete the pattern.
6) Delete all patterns.
[Copy/Delete parameter]
Parameter Setting range Default
Original pattern No. 1 ~ 100 1
Copied pattern No. 1 ~ 100 1
Deleted pattern No. 1 ~ 100 1
3. Pattern name setting
1) Go to other page. Up to 8 pattern names can be set per page.
2) Change a pattern name. If the language is Korean, use Caps to enter
“Korea -> English upper case -> English lower case”. If the language is English/Chinse,
“English upper case -> English lower case” can be entered
nn : 1 ~ 100
[Pattern name parameter]
Parameter Setting range Default
Pattern name nn Up to 23 characters PATTERN NAME nn
①
②
③
④
⑤
⑥
Fig. 71) Pattern copy/deletion
Fig. 72) Pattern name