HANYOUNG NUX TD510 Series - Page 57

55
Installation
Before starting
Operation
Screen block
diagram
Function setting Program System setting Specifications
Parameter 설정범위 초기값
Sensor type Refer to range table by sensor type. K-1
RTD upper limit / TC upper limit
/ DCV input upper limit
Within DCV sensor range
RTD is not entered.
Input upper limit
RTD lower limit / TC lower limit
/ DCV input
Within DCV sensor range
RTD is not entered.
Input lower limit
Upper limit of use range EU (0% - 100%) EU 100 %
Lower limit of use range EU (0% - 100%) EU 0 %
Position of decimal point 0, 1, 2, and 3 1
Input filter 0 - 120 S 0 S
Display unit ℃, Ω, V, mV, %, and User-define ℃
User-define Up to 6 characters UNITnn
1. Compensation value
- Offset is compensated for a temperature measurement. 2. Sectional compensation
- It is used to compensate error by section.
- Set temperature for a base point to compensate temperature.
- Set compensation temperature for each base point.
▶ Temperature compensation
● Compensation parameter
Parameter Setting range Default
Compensation value EUS(0 % - 100 %) 0
Partial compensation value -50.0 - 50.0 0
•Partial compensation changes angle of section so define sections by purpose
to set the values.
Caution
Fig. 83) Sectional compensation(Ch.1) Fig. 84) Sectional compensation(Ch.2)