Harbor Breeze BARNSTAPLE BAY E-RLG52BNK5C User Manual (English)

Questions and Answers:

S
schwartzjamieAug 8, 2025
What to do if my Harbor Breeze BARNSTAPLE BAY E-RLG52BNK5C is not working?
- T
  Tammy DanielAug 9, 2025
  If your Harbor Breeze Fan isn't moving, there could be a few reasons. First, make sure the reverse switch is fully engaged by pushing it firmly either up or down. Second, check if the power is on or if a fuse has blown, and correct as necessary. Lastly, a faulty wire connection could be the problem. To check, turn the power off, loosen the canopy, and inspect all connections.
B
Billy CollinsAug 16, 2025
What to do if my Harbor Breeze BARNSTAPLE BAY E-RLG52BNK5C operates but the lights fail?
- D
  dreynoldsAug 16, 2025
  If your Harbor Breeze Fan is running but the lights aren't working, start by ensuring the bulbs are correctly installed. Next, check the wires in the canopy to make sure they are wired properly according to instructions. Ensure that the wall switch to the light is turned on. Also, verify that the molex connections in the light kit fitter are connected properly according to instructions. Finally, make sure the light kit is not using more than the allowable 190W; if it is, use bulbs that total no more than 190W.
E
Elizabeth ClarkAug 25, 2025
Why is my Harbor Breeze BARNSTAPLE BAY E-RLG52BNK5C wobbling excessively?
- G
  Glenn LesterAug 25, 2025
  Excessive wobbling can occur due to several reasons. The blades may be loose, so ensure all blade screws are tightened. The blade arms might be incorrectly attached, requiring re-installation. Unbalanced blades can also cause wobbling; try switching one blade with a blade from the opposite side or use a balancing kit. The fan may not be securely mounted, so verify the mounting bracket is secure after turning the power off and carefully loosening the canopy. If the fan is too close to a vaulted ceiling, use a longer downrod or move the fan. Also, check the set screws on the motor housing yoke and the hanging ball to ensure they are tightened securely.
E
Eric GarciaAug 31, 2025
How to fix a noisy Harbor Breeze BARNSTAPLE BAY E-RLG52BNK5C?
- D
  Dustin DavisAug 31, 2025
  A noisy Harbor Breeze Fan can be caused by several factors. Check if the blades are loose and tighten all blade screws. A cracked blade will also cause noise, so replace it if necessary. If you are using a full range dimmer switch, replace it with an approved speed control device. If the fan is new, allow it a “break in” period of a few days, especially when running the fan at Medium and High speeds.