Harbor Breeze CLRO52-II User Manual (English)

Questions and Answers:

S
Sean JohnsonAug 1, 2025
Why is my Harbor Breeze CLRO52-II Fan wobbling so much?
- J
  Jennifer JohnsonAug 1, 2025
  If your Harbor Breeze Fan is wobbling excessively, there are several potential causes. First, check and tighten all blade screws. If that doesn't solve the issue, the blade brackets might be incorrectly attached; try reinstalling them. Unbalanced blades can also cause wobbling, so switch a blade with one from the opposite side. Ensure the fan is securely mounted by turning the power off, carefully loosening the canopy, and remounting it securely. Finally, if the fan is too close to a vaulted ceiling, consider lowering it or moving it to another location.
M
Michael RobertsonAug 11, 2025
How to fix a noisy Harbor Breeze CLRO52-II?
- R
  ruizbenjaminAug 11, 2025
  If your Harbor Breeze Fan is operating noisily, start by tightening all blade screws, as loose blades can be a common cause. If the noise persists, inspect the blades for cracks and replace any cracked blades by calling customer service. Also, ensure you are using an approved speed control device, as unapproved ones can cause noisy operation. Replace it with an approved speed control device if needed.
T
timothyrodriguezAug 21, 2025
What to do if my Harbor Breeze CLRO52-II does not move?
- C
  Chad BassAug 21, 2025
  If your Harbor Breeze Fan is not moving, there could be a few reasons. First, make sure the chain switch is not in the “off” position; pull the chain switch to turn it on. If that doesn't work, there might be a faulty wire connection. In this case, turn the power off, loosen the canopy, and check all connections. Finally, ensure the reverse switch is fully engaged by pushing it firmly either way.

Harbor Breeze CLRO52-II Specifications

General

Type	Ceiling Fan
Blade Span	52 inches
Motor Type	AC Motor
Number of Blades	5
Light Kit Included	Yes
Control Type	Pull Chain
Finish	Bronze
Model	CLRO52-II
Motor Speed	3-speed
Reversible	Yes
Indoor/Outdoor	Indoor
Material	Metal