Harbor Breeze CUMBERLAND 42476 User Manual (English)

Questions and Answers:

M
Michael MartinezAug 9, 2025
How to fix a Harbor Breeze Fan remote that is not working?
- M
  Maria SchmidtAug 9, 2025
  If your Harbor Breeze fan remote isn't working, try these steps: * To re-sync the wall control to the fan, switch the power to the fan off and back on again. Within 30 seconds, press and hold the HIGH SPEED and LOW SPEED buttons (or the “LEARN” button, located in the battery compartment) for 5 seconds. The fan will turn on at low speed and the light will turn off, confirming the syncing process. * Insert new CR2032 batteries into the battery compartment of the wall control. * If there are several fans nearby, turn off the power to the other fans and re-sync the remote.
A
Abigail AlvarezAug 15, 2025
What to do if my Harbor Breeze CUMBERLAND 42476 Fan is not moving?
- J
  johnnywatersAug 15, 2025
  If your Harbor Breeze fan isn't moving, try the following: * Ensure the power is on and check the fuse. * Turn the power off, loosen the canopy, and check all connections. * Verify that the connectors from the light kit fitter and fan are properly connected. * Make sure the reverse switch is completely pushed to the left or right.
K
Karen HallAug 22, 2025
How to fix lights not working on Harbor Breeze Fan?
- S
  Sherri MurrayAug 22, 2025
  If your Harbor Breeze fan is working but the lights are not, check these: * Ensure that the 6-pin connectors from the light kit are properly connected. * Turn the power off and check all connections at the ceiling outlet box.
B
Brandi RomeroAug 28, 2025
What to do if my Harbor Breeze CUMBERLAND 42476 Fan is wobbling excessively?
- D
  Donna TorresAug 28, 2025
  Excessive wobbling in your Harbor Breeze fan might be due to loose components or installation issues. Here's what you can do: 1. Check and tighten all screws that connect the fan blades to the blade arms and the blade arms to the motor. 2. Try switching one blade with a blade from the opposite side. Alternatively, use a blade balancing kit. 3. Turn off the power, loosen the canopy, and ensure the mounting bracket is securely attached to the electrical outlet box. The bracket should be flush against the outlet box without any movement. 4. Lift up the yoke cover and tighten the set screw to the yoke until secure.
J
Jacqueline JohnsonSep 3, 2025
Why is my Harbor Breeze CUMBERLAND 42476 noisy?
- J
  javier91Sep 3, 2025
  A noisy Harbor Breeze fan can stem from several causes. Try these solutions: * Check and tighten all screws that hold the fan blades to the blade arms and the motor. * Replace any cracked blades. * Ensure that you are not using a full range dimmer switch to control the fan speed. * Make sure the outlet box is securely attached to the building structure. * Confirm that the mounting bracket is secured to the outlet box and that the screws are tight.

Harbor Breeze CUMBERLAND 42476 Specifications

General

Brand	Harbor Breeze
Model	CUMBERLAND 42476
Type	Ceiling Fan
Number of Blades	5
Motor Speeds	3
Remote Control Included	Yes
Indoor/Outdoor	Indoor
Reversible Motor	Yes
Motor Type	AC
Control Type	Remote control
Blade Span	52 inches
Mounting Options	Downrod