This fan can be mounted as a flushmount on a
regular (no-slope) ceiling only.
Check to make sure blades (F) will be at least
30 in. from any obstruction and at least 7 ft. above
the floor.
7
2.
Locate preassembled mounting plate screw (I) on
outer edge of mounting plate (A) closest to the
J-hook (located on underside of mounting plate
(A)) and remove that mounting plate screw (I).
Then, remove mounting plate screw (I) on outer
edge of mounting plate (A) directly opposite the
mounting plate screw (I) that was just removed.
Partially loosen the other two remaining mounting
plate screws (I).
3.
INITIAL INSTALLATION
3
I
I
A
2
7 ft.
min.
30 in.
min.
F
Secure mounting plate (A) to outlet box using
screws, spring washers and flat washers provided
with the outlet box.
*NOTE: It is very important you use the proper
hardware when installing the mounting plate (A)
as this will support the fan.
4.
4
A
J-hook
To Next Page
Loading...
Need help?
General
